GM Lighting LOC2-TP-60 60-Inch Low-Profile Tape-to-Power Wire Connector
In stock
About this item
About this item
- 60-Inch Power Feed: The nominal 60-inch tape-to-power connector provides a power-feed lead for LTR-S Ultra tape.
- Two-Conductor Wire: White/white stripe jacketed 18/2 AWG wire provides the lead for the power connection.
- Low-Profile Connection: GM Lighting lists this LOC2 connector as a low-profile option for LTR-S Ultra installations.
- Snap-Closed Tape End: The prepared tape slides into the connector and snaps closed with pins aligned to the copper pads.
- 5-Amp Maximum: The connected tape load must stay within the connector maximum and power supply rated output, with tape run limits observed.
Description
Description
GM Lighting LOC2-TP-60 is a 60-inch low-profile tape-to-power wire connector for feeding LTR-S Ultra LED tape. White/white stripe jacketed 18/2 AWG wire provides the power-feed lead.
Cut tape only at designated trim points, peel back 1/4 inch of adhesive backing, and slide the tape into the connector. Align pins with the copper pads, maintain positive and negative polarity, and snap the connector closed.
Use an appropriate GM Lighting power supply, supplied separately, and follow its wiring instructions. Maximum current through the connector is 5A. Do not exceed the power supply rated output. Observe tape maximum run limits and test the system before final installation. LED tape is required separately.
Specifications
Specifications
Dimensions
Documents
Item Details
Frequently Asked Questions
What does this connector do?
What does this connector do?
How long is the power-feed lead?
How long is the power-feed lead?
How does it differ from LOC2-TP?
How does it differ from LOC2-TP?
Can it connect directly to 120V power?
Can it connect directly to 120V power?
What current limit applies?
What current limit applies?
